USD
EUR
GBP
CAD
AUD
HKD
JPY
RUB
CNY
SGD
NZD
FJD
Special design for removing or reinstalling Studs without damaging the thread.
Stud Sizes: M6X 1.0MM; M8X 1.25MM; M10X 1.25MM; M10X 1.5MM
Each size uses one tool for removal and one for installation
Using Instruction:
Stud Sizes: M6X 1.0MM; M8X 1.25MM; M10X 1.25MM; M10X 1.5MM
Each size uses one tool for removal and one for installation
Using Instruction:
Remove
1.Screw the remover onto cylinder stud as possible reach the top of remover.
2.Operate 2 wrenches (fit both sizes) and lock both parts together.
3.Keep the wrench and screw it until cylinder stud is removed.
2.Operate 2 wrenches (fit both sizes) and lock both parts together.
3.Keep the wrench and screw it until cylinder stud is removed.
Install
1.Screw the new stud into installer until reaching steel ball.
2.Screw the stud into the cylinder hole.
3.Loosen the small screw on the top of installer when the work is done, and then you could loose the installer easily.
2.Screw the stud into the cylinder hole.
3.Loosen the small screw on the top of installer when the work is done, and then you could loose the installer easily.
You May Like
-
AUD12.00
-
AUD48.00
-
AUD30.00
-
AUD208.00
