21 pieces ball joint adaptor set is designed to operate on most cars and light trucks that have press-fit type ball joints at your little cost. It allows you to conveniently operate without removing the control arm from the vehicle.

Set includes all the receiver tubes and removing/installing adapters needed to work on press-fit upper and lower ball joints on most GM, Ford, and Dodge 2 and 4 wheel drive Pickups, Vans and Sport Utility vehicles through 1997.
Ball joints are the pivot between the wheels and the suspension of an automobile. There are commonly only two ball joints in the suspension, however there will be at least four (track rod ends and rack ends) in the steering linkage.

The C frame and forcing screw helps you to safely remove and replace joint brake anchor pins, ball joints, and universal joints.

21pc kit includes:

• Receiving tube OD:2 -12" IO: 2 -14" L: 2"
• Installation adaptor
• Removal adaptor
• Receiving cup adaptor OD: 2-1/4" IO: 2" L 2"
• Receiving cup OD: 2-1/8" IO: 1-3/4" L 1/2"
• Remover installer OD: 1-7/16" IO: 3/4" L I
• Receiving cup OD 2-1/2" IO 1-1/4" L 1-1/2"
• Receiving tube OD: 2-3/4" IO:1-7/16" L 2-1/4"
• Receiving tube OD: 3" IO: 2-3/4" L 2-1/4"
• Receiving cup OD 2-1/4" IO 2" L 2"
• Receiving tube OD: 2-1/2" IO: 2-1/4" L 2 -3/4"
• Installation cup OD: 2" IO: 1-/34" L 2-5/16"
• Receiving cup OD 2-7/8" IO 2-5/8" L 3-7/8"
• Receiving cup OD 2-7/16" IO 2-3/16" L 3-3/16"
• Installation cup OD: 2" IO: 1-/34" L 3"